Q45 diff to driveshaft flange

  • #1

    Q45 diff to driveshaft flange

    Hey guys I have been calling driveshaft shops to get the flange for my driveshaft since I went with a Q45 diff on my s13 subframe swap and none have the specs for them :-? . Just wanted to know if anyone knows the specs or where I can buy one?

    Thanks,
    Cesar
  • #2
    Take it off and give it to them.. or swap in the s13 flange?
  • #3
    Yeah thats what I will end up doing the thing is it's a 2 hour drive plus everything is all bolted up but I might have to just take it down and take the diff.
  • #4
    Or to a chalk template of it on paper if you feel artsy
  • #5
    Found this while searching http://www.drive-lines.com/catalogs/mas … nge%20yoke seems like the part number is 3102-69 but will verify tomorrow
  • #6
    This is what I sent Shaftmasters when I ordered my driveshaft. Ignore the length if you're using a stock tranny, 1010mm is if you have a z32 transmission/s14 sub-frame combo.

    1988 SS #71

    Better to remain silent and be thought a fool, than to speak and remove all doubt.
  • #7
    Thank you sir you are a life saver. Are you using the 90-96 diff?
  • #8
    I'm not really sure if I have the 90-96 or the 97-01 diff. The guy I bought if from told me but I forgot.
    1988 SS #71

    Better to remain silent and be thought a fool, than to speak and remove all doubt.
  • #9
    Do you have 5 bolt or 6 bolt axles?
  • #10
    They are 6 bolt axles
    1988 SS #71

    Better to remain silent and be thought a fool, than to speak and remove all doubt.
  • #11
    Nice! So that means you have a 90-96 q45 diff, you have a q45 axle and one twin turbo axle correct? Later ones are 5 bolt axles