Axle shaft dummy to bench test CLSD break away torque

Pete87T

Member

Posts: 32
#1

Axle shaft dummy to bench test CLSD break away torque

12-15-2012, 11:22 PM

I'm re-building the diff, putting extra clutches in, etc.
Does anybody have or know where to get nissan special tool KV38105110? This is a rear axle shaft dummy
for measuring break away torque.
Just figured I would ask if anybody has something lying around that I can borrow (yes reward offered) before
I spend(waste) time and money to destroy a half-shaft and machine in the female end of a 1/2" drive…
Russ84na

Senior Member

Posts: 700
#2

12-16-2012, 08:46 PM

When I rebuilt my CLSD I made the jig to hold the diff and half shafts. the bar is a 1" steel tube about 3 ft long with the torque wrench attached to it. I think I read about it in the FSM.

[attachment=0:2nrmk3y9]Differential internal 004 (Medium).jpg[/attachment:2nrmk3y9]

…and how much HP do you have at 0 boost
Pete87T

Member

Posts: 32
#3

12-17-2012, 10:43 PM

I was thinking of something like that as well, except having the internals sitting loosely in the carrier with a halfshaft in the vice and the other on a torque wrench.

Functional but probably not the best way.

I'll figure something out