Tri-Tri hybrid axle positioning spring cut?

  • #1

    Tri-Tri hybrid axle positioning spring cut?

    I have j30/z31 hybrid t-t axles that are going in my 87. How much of this positioning spring can I cut?
    1987 N/A-to-Turbo
    VG33ET
    Holset WH1C
    Stance Coils

    viewtopic.php?f=13&t=15468
  • #2
    Nnever mind. I got them to fit. I had to put the wheel side in first then bring the diff side down from above the flange at an angle. Very tight fit, I'm a little worried about them binding up when the suspension is compressed.
    1987 N/A-to-Turbo
    VG33ET
    Holset WH1C
    Stance Coils

    viewtopic.php?f=13&t=15468
  • #3
    You should check for binding when the shafts are parrellel to the ground.
    Bolt on, fast, z31. You can only pick two.
    Old weaksauce numbers: 391hp/433tq

  • #4
    Yeah I'm going to jack up on the control arm and spin the wheel. I would hate to hit a bump and blow up one of my new joints. Thanks
    1987 N/A-to-Turbo
    VG33ET
    Holset WH1C
    Stance Coils

    viewtopic.php?f=13&t=15468