Microtech on Matrix mode: Need hand-holding.

Butter

Senior Member

Posts: 1519
#1

Microtech on Matrix mode: Need hand-holding.

04-15-2015, 04:46 PM

Fix this.

I think the brown and the blue upper rpm area was road tuned years ago by me, but I can't remember. Tell me something to get me close, so I don't waste a ton of time that I don't have.

sigpic
88sinZ

Senior Member

Posts: 2019
#2

04-15-2015, 07:55 PM

Take hose cutter..
HoseCutter.jpg

Cut wiring harness.

Install TEC3.
Butter

Senior Member

Posts: 1519
#3

04-16-2015, 12:02 AM

The Z is running a TECgt, so I already know how much better it is (in a lot of ways, not really).

sigpic