Haltech wire harness

  • #1

    Haltech wire harness

    So after Matt from nistune answered some questions he recommended I switch to a standalone. Thinking of grabbing a haltech 2500. Would love to find a male pin pigtail/connector that would match our ECU so I can just wire it up without cutting the original harness. Is anyone using a haltech and found an easy way?
    Usual Z31 suspect: Garage Queen (aka broken)
  • #2
    Finding an inline variation of that vintage of a connector could be nearly impossible, but you could make your own by desoldering the connectors off of a donor ECU and soldering them to a perfboard, making your own break-out board.

    A few years ago i did some disassembly of one and found that the FI connector was made by AMP, but the others i could not determine.


    84 AE/Shiro #683/Shiro #820/84 Turbo
  • #3
    I can just use something like this and jump 2 pigtails together I would assume?

    Usual Z31 suspect: Garage Queen (aka broken)
  • #4
    This seems like an option too. Obviously would have to figure out what the pin sizes are.

    Usual Z31 suspect: Garage Queen (aka broken)
  • #5
    Yeah you could totally use jumpers into the Z31 harness plugs and then pot them in place, as long as like you said, pin diameter is correct and makes a good contact.



    84 AE/Shiro #683/Shiro #820/84 Turbo