Did some maintenence

I would of remachined the brake rotors aswell while you were at it…

No YOU wouldnt have cause for some reason in AU they charge an arm and a leg to machine them.

DAHAHAHAHAHAHAHA :lol: :lol:

lol You're confusing the cost of what the caliper seal kit cost me from Nissan here, $180! :|

Aftermarket caliper rebuild kit for $40 for the gtr brakes FTW!!

I coulda swore you and I were talking and you said that Nobody would machine rotors for less that like 60 bucks or somthing stupid like that where you are. I remember cause I said you can get NEW rotors for less than that!

[quote]SATAN wrote: Yeah 60 bucks sounds about right. Oh and could you point me in the direction where I could get rotors for 60 bucks to down here.

Slotted rotors are about 250 bucks for a pair down here. We get reamed down here, I just ordered US$150 worth of gear for my front end from Black Dragon Auto over there, same amount of stuff over here would cost me AU$615

[quote]SATAN wrote: Yeah that is about right for a pair, compared to new stock rotors which are about $200 here from Nissan.

Yeah we get raped a bit, I think it's mainly because almost every Z31 part you can get here is a special order item and something they rarely have in stock.

You guys From AU should just have US guys get you stuff, and ship it there…

Yeah, there's alot of stuff from here too that guys in the U.S want that you can only get here side as the rear 1/4 panel vents and single headlights etc

Here's another example of the bullshit I have to put up with, I was doing the injectors today on the '88 aswell as soldering on new injector connectors and during the process I noticed that the air regulator hose was starting to break down. Called Nissan, $21 dollars for that hose which is probably about 2 inches of rubber! LOL

We sure do get ripped off.

Perhaps we could organise a bit of marketing between countries. :P