Bearings - Z31 Performance

shane vincent

Junior Member

Posts: 10
#1

Bearings

02-21-2010, 11:01 PM

So i asked over at Z31.com with no reply to my post so i figured id ask here.
Cant remember witch bearings to use for the dett rods in a 12v motor. I know its been speculated the 12v bearings are better and the journal sizes are the same but didnt the dett rods have a small hole in the bearing for the wrist pin oiling? if that were the case i guess i awnserd my own question. dett rod bearings in a 12v motor.
ZFast88Z

Senior Member

Posts: 1882
#2

02-21-2010, 11:42 PM

VG30ET bearings in an VG build

The bullshit stops, when the GREEN light drops.

Only babies cry about the bottle.
shane vincent

Junior Member

Posts: 10
#3

02-22-2010, 12:35 AM

Thankyou very much and use the the z32 40ftlbs on the rods right.
SATAN

Senior Member

Posts: 6782
#4

02-22-2010, 01:57 AM

shane vincent wrote: Thankyou very much and use the the z32 40ftlbs on the rods right.

Yes, whatever the torque specs are for those rods. I thought it was like 46ft/lbs, but if the manual says 40, then 40 it is.

85 Z31 6.0 LSX turbo 766whp/792wtq
04 GTO, LS6, big cam, porting, N20… underway for summertime daily driver.