Aftermarket Tie Rods and Adding More Angle

G-E

Junior Member

Posts: 6320
#61

06-09-2013, 10:09 PM

Should have shown him one with the wheel turned out so he can see the way everything attaches
Pauls

Member

Posts: 64
#62

06-10-2013, 05:49 PM

Ok. I get it now, it's a decent learning curve, however I don't agree with the negative cant be done attitude.
exploring s14 setup has helped me get my head around this.
Looked into z32 which is freakish setup.
So going back to z31 hubs & knuckles, goal is to test fit my 08 g37s rotors and get caliper adaptor made up for the same aekbono callipers.
Next will be adaptor that slides into cut down z31 tube that has holes to bolt upto s14 coilovers.
i just hope spindles are the same!

Love z31's as much as I do? Check out my build: http://www.zdriver.com.au/index.php/…__80#entry2219
jaqattack02

Senior Member

Posts: 1185
#63

06-10-2013, 09:30 PM

Why don't you make your own thread to talk about it, rather than hijacking this one?

Prius… because Pretentious wouldn't fit across the back of the car…

Cheap, Fast, Reliable - pick any two

My 1986 Turbo Build
Pauls

Member

Posts: 64
#64

06-11-2013, 12:08 AM

jaqattack02;334595 wrote: Why don't you make your own thread to talk about it, rather than hijacking this one?

Sorry dude, started with tie rods and as usual the problem was deeper ending up at spindle, hubs etc.

Love z31's as much as I do? Check out my build: http://www.zdriver.com.au/index.php/…__80#entry2219