NA2T Detonation Knock Sensor Location

  • #1

    NA2T Detonation Knock Sensor Location

    Hey y’all so here’s the run down I have an 86 NA engine that I am slapping all the turbo components on and putting in a 85 Turbo chassis which is where most of the turbo parts are from. I have the engine out with 80% of turbo stuff on and need to install knock sensor. I read elsewhere it says stock Location is on passenger block below cyl #1 and I found the suspected spot and removed the bolt come to find out Haynes states that is a “coolant draincock” but the picture representation they use is an NA. Is that the actual spot, on the coolant channel?
    Attached Files
    • 0F852C0F-DAE0-4C7D-A70C-C0F85AA6105B.jpeg (236.9 KB)
    Tags: na2t knock sensor
  • #2
    https://youtu.be/RoI5PIj6CY0?t=376
    shows location of knock sensor How To Remove A 1984-1989 300ZX Engine (VG30ET)

    • 1 like
  • #3
    The approximate location is also shown in the FSM.

    2011-03-30_215930_87_300z_detonation_sensor.jpg
  • #4
    Okay thanks y’all. What’s funny is I have seen that video before didn’t notice he was talking about the knock sensor.
  • #5
    What seems to be the right location on my block is wayyyy to small to accept the knock sensor I have. The one I have is from an 88 I wonder if that makes a difference. I did find a non-water channel hole to put it in though, does anyone thing this would not function properly in this location?
    Attached Files
    • 6A9B5D35-DF91-488A-8B7D-D4A7D2B189BD.jpeg (1.89 MB)
  • #6
    Haha after further review of the video I find that my new location is in fact the correct location. Thanks for the help y’all