VG33 Crank Spacer for Z32 Pulleys

Previous 1 2

BLOZ UP

Senior Member

Posts: 2971
#16

05-14-2015, 11:46 AM

I had my spacer machined to fit inside the Z32 ATI Damper. Works!

Had some issues pushing the pulley on, but once I torqued it all the way on (difficult since a proper pulley installer doesn't fit) things worked out.

So the ATI damper works with the VG33. Comes real effin close to the timing cover/timing cover lower bolt, but doesn't hit.

Not that timing marks are indexed incorrectly.

BLOZ UP.com
It is not recommended to confirm proper installation by driving into walls or other barriers as this could cause personal injury or damage to the vehicle.
ZEricMZ

Senior Member

Posts: 455
#17

05-14-2015, 09:20 PM

I will take one, message being sent.

Build Log Link: http://z31performance.com/showthread…-VG33-HX35-WIP
BLOZ UP

Senior Member

Posts: 2971
#18

05-14-2015, 09:52 PM

Sale pending for last one.

BLOZ UP.com
It is not recommended to confirm proper installation by driving into walls or other barriers as this could cause personal injury or damage to the vehicle.
zdriver_kado

Member

Posts: 100
#19

05-15-2015, 12:37 PM

I'm game to try one if sale falls through.
BLOZ UP

Senior Member

Posts: 2971
#20

06-01-2015, 11:31 AM

One left!

BLOZ UP.com
It is not recommended to confirm proper installation by driving into walls or other barriers as this could cause personal injury or damage to the vehicle.
amreboot

Banned

Posts: 9875
#21

11-02-2015, 11:34 AM

Heya.... I need one of these.
BLOZ UP, I know you don't have any left, but I am curious if anyone has one that they are not using.

Lemme know…

Previous 1 2