Geoffs VG34T build thread!!!

Geoffs86zx

Member

Posts: 59
#16

02-03-2016, 01:26 PM

more pix20160201_092801.jpg20160201_093502.jpg20160201_093433.jpg20160128_151754.jpg20160201_093239.jpg
Geoffs86zx

Member

Posts: 59
#17

02-03-2016, 01:31 PM

20160201_094759.jpg20160201_095857.jpg20160201_094231.jpg20160201_093850 (1).jpg20160201_093840.jpg
Geoffs86zx

Member

Posts: 59
#18

02-03-2016, 01:36 PM

00N0N_aT9XMW6i97i_600x450.jpg
Geoffs86zx

Member

Posts: 59
#19

02-03-2016, 01:41 PM

i am missing my cross over exhaust pipe. must have lost it in the move.
gunna need that.
Geoffs86zx

Member

Posts: 59
#20

02-03-2016, 04:53 PM

Originally posted by Geoffs86zx View Post

[ATTACH=CONFIG]2281[/ATTACH]

20160201_094231.jpg20160201_093936.jpg
my built and assembled vg33 long block and my vh45
Geoffs86zx

Member

Posts: 59
#21

02-03-2016, 04:57 PM

so i put a pic of the milled z31 crank pulley next to a stock one. to see the difference in meat left.. as i recall our discussion about it being doable or safe, i remember my machinist showing me a sc350 crank pulley and there was less "meat" around the crank snout on the sc350 crank pulley than my custom milled one.